LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1075 (Engine Mechanical - 6.6L (4 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 4) >> Oil Pump Cleaning and Inspection

Oil Pump Cleaning and Inspection

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Gear Cover & Bolts
    GM663597Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil pump gear cover bolts.
  2. Remove the oil pump gear cover.
    3. Fig 2: Measuring Clearance Between Gear Teeth & Oil Pump Housing
    GM663599Courtesy of GENERAL MOTORS CORP.
  3. Use a feeler gauge to measure the clearance between the gear teeth and the oil pump housing. The production clearance is 0.125-0.221 mm (0.0049-0.0087 in) and the service limit is 0.221 mm (0.0087 in).
  4. Replace the oil pump assembly if the clearance exceeds the service limit.
    5. Fig 3: Measuring Clearance Between Side Of Gear & Cover
    GM663603Courtesy of GENERAL MOTORS CORP.
  5. Use a feeler gauge and a straightedge to measure the clearance between the side of the gear and the cover. The production clearance is 0.064-0.109 mm (0.0025-0.0043 in) and the service limit is 0.109 mm (0.0043 in).
  6. Replace the oil pump assembly if the clearance exceeds the service limit.
    7. Fig 4: View Of Driven Gear Shaft & Bushing Measurements
    GM663609Courtesy of GENERAL MOTORS CORP.
  7. Calculate the driven gear shaft to bushing clearance.
    1. Measure the driven gear shaft outside diameter. The production specification is 19.947-19.960 mm (0.7853-0.7858 in) and the service limit is 19.86 mm (0.7819 in).
    2. Measure the driven gear bushing inside diameter. The production value is 20 mm (0.7874 in).
    3. Calculate the driven gear shaft to bushing clearance. The service limit is 0.14 mm (0.0055 in)
  8. Replace the oil pump assembly if the clearance exceeds the service limit.
    9. Fig 5: View Of Oil Pump Gear Cover & Bolts
    GM663597Courtesy of GENERAL MOTORS CORP.
  9. Install the oil pump gear cover to the oil pump assembly.
    10. NOTE: Refer to Fastener Notice .
  10. Install the oil pump gear cover bolts.

    Tighten:  Tighten the oil pump gear cover bolts to 21 N.m (15 lb ft).

scientia non olet · About LEMON Manuals