Fuel Injector Cleaning and Inspection

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fuel Injector Nozzle Tip & Copper Washer Sealing Area

Courtesy of GENERAL MOTORS CORP.

Use a soft bristle non-metallic brush and top engine cleaner, GM P/N 1052626 or equivalent, to remove any deposits from the nozzle tip (1) and the copper washer sealing area (2) before reinstallation.

NOTE: The fuel injector must be cleaned with the proper cleaning equipment. DO NOT use abrasive cleaning methods, such as a metallic brush, to remove deposits. Cleaning an injector with improper tools will damage the fuel injector.

Inspect the fuel injector nozzle tip (1) for cracks, dents, or other damage.
Inspect the nozzle tip (1) for any signs of discoloration - dark yellow, tan, or blue due to excessive heat.
Replace the injector if any damage is found.

Fig 2: View Of Fuel Injector Sealing Surfaces

Courtesy of GENERAL MOTORS CORP.

Clean the fuel injector high pressure line.
Inspect the fuel injector high pressure line for excessive corrosion or damage to the sealing surfaces (1, 2). Replace the line if any damage is found.