LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1072 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Valve Lifter, Guides, Retainers & Bolts
    GM660517Courtesy of GENERAL MOTORS CORP.
  1. Apply clean engine oil to the roller and outside of the valve lifter.
  2. Install the valve lifter.
  3. Install the valve lifter guides.
  4. Install the valve lifter guide retainer.
    NOTE: Refer to Fastener Notice .
  5. Install the valve lifter guide retainer bolt.

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  6. Install the cylinder head. Refer to Cylinder Head Replacement - Left Side  or Cylinder Head Replacement - Right Side .
scientia non olet · About LEMON Manuals