LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1072 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Turbocharger Oil Feed Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Feed Pipe Bolt, Washer & Pipe
    GM1335581Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not twist the turbocharger oil feed pipe. Twisting of the feed pipe will result in the collapse and deformation of the plastic pipe, restricting oil flow and causing turbocharger damage. During turbocharger replacement, gently push the oil feed pipe towards the front of the engine to clear the turbocharger. Assistance may be required to keep the pipes clear of the turbocharger during removal or installation.
    IMPORTANT: Lubricate the NEW washer with diesel fuel before installing.
    NOTE: Refer to Fastener Notice .
  1. Position the oil feed pipe and a NEW washer into place.
  2. Install the oil feed pipe bolt.

    Tighten:  Tighten the bolt to 34 N.m (25 lb ft).

  3. Install the turbocharger. Refer to Turbocharger Replacement .
scientia non olet · About LEMON Manuals