LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1072 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pressure Sensor
    GM1364822Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Apply sealant to the threads of the oil pressure sensor. Refer to Sealers, Adhesives, and Lubricants for the correct part number.
  2. Using J 41712  , install the oil pressure sensor (1).

    Tighten:  Tighten the sensor to 49 N.m (36 lb ft).

    3. Fig 2: View Of Oil Pressure Sensor Electrical Connector
    GM1335546Courtesy of GENERAL MOTORS CORP.
  3. Connect the oil pressure sensor electrical connector.
  4. Install the left wheelhouse inner panel. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
  5. Check and add engine oil if necessary.
scientia non olet · About LEMON Manuals