LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1072 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Crankshaft Rear Oil Seal Using J 44641
    GM660312Courtesy of GENERAL MOTORS CORP.
  1. Remove the flywheel. Refer to Engine Flywheel Replacement .
  2. Clean the area around the crankshaft rear oil seal.
  3. Install J 44641  to the crankshaft rear oil seal. See Special Tools .
  4. Remove the crankshaft rear oil seal using J 44641  . See Special Tools .
scientia non olet · About LEMON Manuals