LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1063 (Engine Mechanical - 4.3L) >> Repair Instructions - Off Vehicle >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Level Indicator Tube Sealant
    GM188009Courtesy of GENERAL MOTORS CORP.
  1. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent, around the oil level indicator tube 13 mm (0.5 in) below the tube bead.
  2. Install the oil level indicator tube into the engine block. Rotate the oil level indicator tube into position.
    3. NOTE: Refer to Fastener Notice .
  3. Install the oil level indicator tube bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 12 N.m (106 lb in).

    4. Fig 2: Locating Oil Level Indicator
    GM330580Courtesy of GENERAL MOTORS CORP.
  4. Install the oil level indicator into the oil level indicator tube, if required.
scientia non olet · About LEMON Manuals