LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1051 (Engine Controls And Fuel - 6.6L - DTC P02E7 To DTC P0699) >> DTC P0506 or P0507 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTCs are not set. If DTCs are set refer to Diagnostic Trouble Code (DTC) List - Vehicle .
  2. Engine running, compare the scan tool Desired Idle Speed parameter to the Engine Speed parameter. Both engine speed parameters should be within 50 RPM of each other.
  3. Elevate the engine speed in 25 RPM increments to 1,300 RPM using a scan tool. With each commanded increment, the actual Engine Speed parameter should stay within 25 RPM of the commanded speed.
  4. Operate the vehicle within the Conditions for Running the DTC to verify that the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals