LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1046 (Engine Controls And Fuel - 6.6L - DTC P0016 To DTC P02E0) >> DTC P0097 or P0098 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Static Test

  1. Ignition OFF, disconnect the harness connector at the IAT sensor 2.
  2. Measure the resistance between the signal terminal A and the low reference circuit terminal B.
  3. Compare the value to the Temperature Vs Resistance table. Verify the resistance is within 9 percent of the specification. Refer to Temperature Versus Resistance (EGR Temperature Sensors) or Temperature Versus Resistance (ECT Sensors) or Temperature Versus Resistance (Fuel Temperature Sensor) or Temperature Versus Resistance (IAT Sensor 1) or Temperature Versus Resistance (IAT Sensor 2) or Temperature Versus Resistance (EGT Sensors) .
    • If not within the specified range, replace the IAT sensor 2.

Dynamic Test

    IMPORTANT: A thermometer can be used to test the sensor off the vehicle in heated water.
  1. Test the IAT sensor 2 by varying the sensor temperature while monitoring the sensor resistance.
  2. Compare the readings with the Temperature Vs Resistance table and verify that the resistance is within 9 percent of the specification.
    • If not within the specified range, replace the IAT sensor 2.
scientia non olet · About LEMON Manuals