Conditions for Running the DTC

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

P0153

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The Engine Coolant Temperature (ECT) Sensor parameter is more than 60°C (140°F).
The Intake Air Temperature (IAT) Sensor parameter is more than -40°C (-40°F).
The Ignition 1 Signal parameter is between 10-18 volts.
The Fuel Level Sensor parameter is more than 10 percent.
The Engine Run Time parameter is more than 160 seconds.
The Engine Speed parameter is between 1,200-3,000 RPM.
The Barometric (BARO) Pressure parameter is more than 70 kPa.
The Mass Airflow (MAF) Sensor parameter is between 20-55 g/s.
The Loop Status parameter is Closed.
The Throttle Position (TP) Indicated Angle parameter is more than 5 percent.
DTC P0153 runs once per drive cycle when the above conditions are met for 1 second.

P0154

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The Ignition 1 Signal parameter is between 10-18 volts.
The engine run time is more than 300 seconds.
DTC P0154 runs continuously when the above conditions are met.

P0160

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The Ignition 1 Signal parameter is between 10-18 volts.
The Engine Run Time parameter is more than 200 seconds.
The Loop Status parameter is closed.
DTC P0160 runs once per drive cycle when the above conditions are met.

P1153

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The ECT Sensor parameter is more than 60°C (140°F).
The IAT Sensor parameter is more than -40°C (-40°F).
The Engine Speed parameter is between 1,200-3,000 RPM.
The Ignition 1 Signal parameter is between 10-18 volts.
The Engine Run Time parameter is more than 160 seconds.
The Loop Status parameter is Closed.
The TP Indicated Angle parameter is more than 5 percent.
The Fuel Level Sensor parameter is more than 10 percent.
The BARO Pressure parameter is more than 70 kPa.
The MAF Sensor parameter is between 20-55 g/s.
DTC P1153 runs once per drive cycle when the above conditions are met for 1 second.

P2272

DTCs P0036, P0037, P0038, P0137, P0138, P0140, P0141, P0443, P0458, P0458, P2232 are not set.
The Ignition 1 Signal parameter is between 10-18 volts.
The Engine Run Time parameter is more than 5 minutes.
The Engine Speed parameter is between 1,100-2,500 RPM.
The MAF Sensor parameter is between 3-20 g/s.
The Vehicle Speed parameter is between 50-120 km/h (31-75 mph).
The Fuel Level Sensor parameter is more than 10 percent.
The Loop Status parameter is Closed.
The Catalytic Converter Temperature parameter is between 550-900°C (1,022-1,652°F).
DTC P2272 runs once per drive cycle when the above conditions are met.

P2273

DTCs P0036, P0037, P0038, P0137, P0138, P0140, P0141, P0443, P0458, P0458, P2232 are not set.
The Ignition 1 Signal parameter is between 10-18 volts.
The Engine Speed parameter is between 500-5,000 RPM.
The MAF Sensor parameter is between 3-50 g/s.
The Vehicle Speed parameter is between 24-132 km/h (15-82 mph).
The Fuel Level Sensor parameter is more than 10 percent.
The Loop Status parameter is Closed.
DTC P2273 runs once per drive cycle when the above conditions are met for 1 second.

P2A04

DTCs P0030, P0036, P0053, P0054, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1516, P2101, P2119, P2135, P2176, P2A00 are not set.
The Engine Run Time parameter is more than 5 minutes.
The ignition 1 Signal parameter is between 10-18 volts.
The MAF sensor parameter is between 3-50 g/s.
The Engine Speed parameter is between 500-5,000 RPM.
The Vehicle Speed parameter is between 24-132 km/h (15-82 mph).
The Fuel Level Sensor parameter is more than 10 percent.
The Short Term FT parameter is between -4 and +4 percent.
DTC P2A04 runs once per drive cycle when the above conditions are met for 1 second.