Charge Air Cooler Outlet Connection (Engine Air Intake COLD Side)
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
It is not necessary to remove the charge air cooler from the vehicle to perform this test.
- Refer to Intake Air Heater Replacement for intake air heater removal.
- Install the J-46091-5 plate and gaskets on the inlet tube studs. See Special Tools .
- Install the 2 intake air heater nuts.
Tighten: Tighten the nuts to 8 N.m (70 lb in).
NOTE:
Refer to Fastener Notice
.