Installation Procedure
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the side heat shield (3).
- Install the side heat shield bolt (4) and nut (5).
Tighten:
- Tighten the bolt (4) to 17 N.m (13 lb ft).
- Tighten the nut (5) to 25 N.m (18 lb ft).
- Install the front heat shield (1).
- Install the front heat shield bolts (2).
Tighten: Tighten the bolts (2) to 17 N.m (13 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
.