LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1035 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Information >> Transmission Fluid Cooler Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Cooling Lines & Transmission
    G00405643Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission oil cooler lines to the vehicle.
  2. Install the cooling lines to the transmission (1). Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  3. Install the engine protection shield. Refer to Engine Shield Replacement .
  4. Lower the vehicle.
    5. Fig 2: View Of Transmission Fluid Cooler Hose
    G00405642Courtesy of GENERAL MOTORS CORP.
  5. Install the transmission fluid cooler hose to the radiator (1). Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
    6. Fig 3: View Of Auxiliary Oil Cooler
    G00405641Courtesy of GENERAL MOTORS CORP.
  6. Install the transmission fluid cooler hose to the auxiliary oil cooler (1). Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  7. Install the radiator grille. Refer to Radiator Grille Replacement (Chevrolet) or Radiator Grille Replacement (GMC) .
scientia non olet · About LEMON Manuals