LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1035 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Information >> Stator Shaft Bushing Replacement >> Replacement

Stator Shaft Bushing Replacement: Replacement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Stator Shaft Bushing With J Tools
    GM1423196Courtesy of GENERAL MOTORS CORP.
    NOTE: Always use J 44529 when removing the stator shaft bushing to help avoid damage to the stator shaft sealing surface.
  1. Position the oil pump cover assembly (10) supported by wooden blocks with the stator shaft facing up.
  2. Install J 44529 -2 bolt (8) into J 44529 -1 extractor (7).
  3. Install J 44529 -2 bolt (8) and J 44529 -1 extractor (7) into the bushing (9).
  4. Install washer (6) and nut (5) onto J 44529 -2 bolt (8).
  5. Hold the top of J 44529 -2 bolt (8) with a wrench and tighten nut (5) until J 44529 -1 extractor (7) engages the bushing (9).
  6. Install J 44529 -3 protector (4) onto J 44529 -2 bolt (8).
  7. Install bearing (3), washer (2), and nut (1) onto J 44529-2 bolt (8).
  8. Hold the top of J 44529 -2 bolt (8) with a wrench and tighten nut (1) until the bushing is dislodged.
  9. Remove the J tools from the stator shaft.
  10. Remove the bushing from the J tools.
    11. Fig 2: View Of Stator Shaft Bushing
    GM1424221Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The preferred method for installing the stator shaft bushing is to use J 43774  and a press. See Special Tools . If a press is not available, use J 43774  and J 8092  universal driver. If the bushing will be installed without a press, install the large end of J 43774  (2) onto J 8092  (1). See Special Tools .
  11. Install a new bushing (3) onto J 43774  . See Special Tools .
  12. Drive the bushing into the stator shaft (4) until the bushing is seated.

    Specification:  The bushing installed depth measurement is flush to 0.25 mm (0.010 in) below the stator shaft surface.

scientia non olet · About LEMON Manuals