Output Speed Sensor Installation (2WD): Installation
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the vehicle speed sensor O-ring (3) onto the output speed sensor (OSS) (2).
- Apply J 36850 to the O-ring (3). See Special Tools .
- Install the OSS (2) into the low and reverse clutch housing, 2WD.
- Install the vehicle speed sensor bolt (1) into the low and reverse clutch housing, 2WD.
Tighten: Tighten the bolt to 12 N.m (108 lb in).
NOTE:
Refer to Fastener Notice
.