Holding Fixture Removal
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Attach a sling to the transmission.
- Attach a hoist to the sling.
- Put moderate lift tension on the hoist.
- Disconnect and remove the transmission from the repair stand.
- Place the transmission on the work table with the oil pan facing down.
- Install the power take-off (PTO) cover gaskets (1)
- Install 2 PTO covers (2).
- Install 12 PTO cover bolts (3).
Tighten: Tighten the bolts to 43 N.m (31 lb ft).
CAUTION:
The 1000 Series™ transmission dry weight is approximately 150 kg (330 lb). To help avoid personal injury and/or property damage: Use caution when installing, removing, or moving the transmission. Get help when lifting the transmission. Assistance from a hoist or another person may be required. Ensure that lifting equipment can properly support the transmission.
NOTE:
Refer to Fastener Notice
.