Steering Gear Rack Bearing Preload Adjustment - Off Vehicle
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the steering gear rack bearing adjuster plug lock nut (1).
- Turn the steering gear rack bearing adjuster plug clockwise until the it bottoms in the steering gear assembly.
- Turn the steering gear rack bearing adjuster plug back 50 degrees to 70 degrees (approximately one flat).
- Install the steering gear rack bearing adjuster plug lock nut (1).
Tighten: Tighten the nut to 68 N.m (50 lb ft).
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
Hold the steering gear rack bearing adjuster plug stationary while tightening the steering gear rack bearing adjuster plug lock nut.