LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1018 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (Diesel) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Gear Inlet Hose & Clip Bolt
    GM1891219Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the power steering gear inlet hose (2) to the vehicle.
  2. Connect the power steering gear inlet hose (4) to the steering gear.

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  3. Install the power steering gear inlet hose clip bolt (3).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  4. Connect the power steering gear inlet hose (1) to the power brake booster.

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  5. Clean any excess power steering fluid from the vehicle and remove the drain pans.
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals