LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1018 (Power Steering System) >> Repair Instructions >> Power Brake Booster Inlet Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Power Brake Booster Inlet Hose
    GM650858Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to INSTALLING HOSES WITHOUT TWISTS OR BENDS NOTICE .
  1. Install the power brake booster inlet hose (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: Start both power brake booster inlet hose fittings by hand before finalizing torques.
  2. Connect the power brake booster inlet hose (1) to the power brake booster (2).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  3. Connect the power brake booster inlet hose (1) to the power steering pump (3).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  4. Clean any excess fluid from the vehicle and remove the drain pans.
  5. Install the engine shield. Refer to Engine Shield Replacement .
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals