LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1001 (Adjustable Pedal System) >> Diagnostic Information and Procedures >> DTC B3631 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X2 harness connector at the left IP junction block.
  2. Ignition ON, transmission in reverse, verify that a test lamp illuminates between the park enable relay control circuit terminal E3 and ground.
    • If the test lamp does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal replace the BCM.
  3. If all circuits test normal, replace the left IP junction block.
scientia non olet · About LEMON Manuals