LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> ENGINE MECHANICAL - 4.8L, 5.3L, AND 6.0L (2 Of 4) >> On-Vehicle Repair Instructions >> Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (RPO LQ4)) >> Installation Procedure

Installation Procedure

    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: View Of Sight Shield Retainer (4.8L, 5.3L & 6.0L)
    GM832095Courtesy of GENERAL MOTORS CORP.
  1. Install the sight shield retainer and the bolts, if required.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

    2. NOTE: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
    Fig 2: View Of Sight Shield (4.8L, 5.3L & 6.0L)
    GM832094Courtesy of GENERAL MOTORS CORP.
  2. Install the intake manifold sight shield to the retainer.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals