LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L80-E/4L85-E - Overhaul >> Repair Instructions >> Low and Reverse Band Servo Assembly Installation

Low and Reverse Band Servo Assembly Installation

    Fig 1: View Of Low & Reverse Accumulator Piston Spring & Band Servo Assembly
    GM40606Courtesy of GENERAL MOTORS CORP.
  1. Install the low and reverse accumulator piston spring (74) into the transmission case.
    2. IMPORTANT: The low and reverse band servo assembly (64-73) is pushed down when tightening the cover bolts. Do not force the low and reverse band servo assembly (64-73) into the servo bore.
  2. Install the low and reverse band servo assembly (64-73).
    3. Fig 2: Installing Low & Reverse Band Servo Cover, Gasket & Bolts
    GM40607Courtesy of GENERAL MOTORS CORP.
  3. Install the low and reverse band servo cover gasket (63).
  4. Install the low and reverse band servo cover (62).
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the 6 low and reverse band servo cover bolts (61).

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft) in an alternating pattern.

scientia non olet · About LEMON Manuals