LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Engine Mechanical - 3.6L (Ly7) (6 Of 6)) >> Off-Vehicle Repair Instructions - Part 4 >> Generator Installation

Generator Installation

WARNING: This page is about a different car, the 2005 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Follow the procedure sequence in order to prevent drive belt mis-alignment and/or possible damage/distortion to the components.
    Fig 1: View Of Generator Bracket
    GM945862Courtesy of GENERAL MOTORS CORP.
  1. Place the generator bracket in position to the cylinder block.
  2. Loosely install the generator bracket bolts.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the front lower generator bracket bolt.

    Tighten:  Tighten the front lower generator bracket bolt to 50 N.m (37 lb ft).

  4. Tighten the front upper generator bracket bolts.

    Tighten:  Tighten the front upper generator bracket bolts to 50 N.m (37 lb ft).

  5. Tighten the side generator bracket bolt.

    Tighten:  Tighten the side generator bracket bolt to 22 N.m (16 lb ft).

    6. Fig 2: View Of Generator
    GM1392404Courtesy of GENERAL MOTORS CORP.
  6. Place the generator in position to the generator bracket.
  7. Loosely install the generator side bolts. Ensure the short bolt is installed in the front lower position.
  8. Hold the generator firmly against the engine block.
  9. Tighten the generator side bolts.

    Tighten:  Tighten the generator side bolts to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals