LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Engine Mechanical - 3.6L (Ly7) (4 Of 6)) >> Off-Vehicle Repair Instructions - Part 2 >> Intake Manifold Disassemble >> Upper Intake Manifold Disassemble Procedure

Upper Intake Manifold Disassemble Procedure

WARNING: This page is about a different car, the 2005 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Throttle Body
    GM1211064Courtesy of GENERAL MOTORS CORP.
  1. Remove the throttle body bolts.
  2. Remove the throttle body.
  3. Remove and discard the throttle body gasket.
    4. Fig 2: View Of Intake Manifold BARO sensor
    GM1507465Courtesy of GENERAL MOTORS CORP.
  4. Remove the barometric (BARO) sensor bolt.
  5. Remove the BARO sensor.
    6. Fig 3: View Of Intake Manifold Communicator Valve
    GM1507466Courtesy of GENERAL MOTORS CORP.
  6. Remove the communicator valve bolts.
  7. Remove the communicator valve.
    8. Fig 4: View Of Intake Manifold Sight Shield Ball Studs
    GM1507467Courtesy of GENERAL MOTORS CORP.
  8. Remove the sight shield ball studs.
    9. Fig 5: View Of Intake Manifold Sight Shield Grommet
    GM1507468Courtesy of GENERAL MOTORS CORP.
  9. Remove the sight shield grommet.
scientia non olet · About LEMON Manuals