LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Engine Mechanical - 3.6L (Ly7) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Fuel Injector Sight Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Engine Cover/Sight Shield
    GM1469395Courtesy of GENERAL MOTORS CORP.
  1. Remove the cross car brace, if necessary. Refer to Brace Replacement - Cross Vehicle in Body Front End.
  2. Remove the oil fill cap.
  3. Disengage the cover/shield from the ball studs by pulling up firmly on the right rear and left front of the engine cover.
  4. Remove the engine cover/sight shield.
  5. Remove the front compartment sight shield, if necessary. Refer to Sight Shields, Hood Adjuster, Hood Bumper, Hood Latch Replacement in Body Front End.
scientia non olet · About LEMON Manuals