LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Engine Mechanical - 3.6L (Ly7) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Fuel Injector Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Engine Cover/Sight Shield
    GM1469395Courtesy of GENERAL MOTORS CORP.
  1. Install the front compartment sight shield, if necessary. Refer to Sight Shields, Hood Adjuster, Hood Bumper, Hood Latch Replacement in Body Front End.
  2. Position the engine cover/sight shield over the intake manifold so the grommets are aligned with the ball studs.
  3. Press the engine cover/sight shield down firmly near the ball studs in order to install the engine cover/sight shield.
  4. Install the oil fill cap.
  5. Install the cross car brace, if necessary. Refer to Brace Replacement - Cross Vehicle in Body Front End.
scientia non olet · About LEMON Manuals