LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Engine Mechanical - 3.6L (Ly7) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Engine Mount Bracket Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Engine Mount Bracket
    GM1283929Courtesy of GENERAL MOTORS CORP.
  1. Install the left engine mount bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the left engine mount bracket retaining bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

    3. Fig 2: View Of Left Engine Mount
    GM1283928Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount to the vehicle.
  4. Install the upper engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

    5. Fig 3: Identifying Frame Mounting Nuts
    GM785352Courtesy of GENERAL MOTORS CORP.
  5. Lower the engine using the screw jack until the weight is resting on the mount.
  6. Install the engine mount lower retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  7. Remove the screw jack and block of wood from under the oil pan.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals