Tools Required

J 38836  Bushing Installer and Clutch Arbor

Fig 1: View Of J 38836, Washer & Pilot Bearing (without RPO HP2)
Courtesy of GENERAL MOTORS CORP.
IMPORTANT: The flywheel spacer, if applicable, must be removed prior to pilot bearing installation.
1. Install a 5/8 inch washer (1) onto the J 38836  or equivalent.
2. Install the new pilot bearing (2) onto the tool.
Fig 2: Installing Pilot Bearing Using J 38836 (without RPO HP2)
Courtesy of GENERAL MOTORS CORP.
3. Install the new pilot bearing into the crankshaft using the J 38836  .
Fig 3: View Of Clutch Pilot Bearing Proper Installation Position (without RPO HP2)
Courtesy of GENERAL MOTORS CORP.
4. Inspect the clutch pilot bearing for proper installation.