LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3) >> Repair Instructions (On-Vehicle And Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement (5.3L Engine w/RPO HP2) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Drive Belt Idler Pulley (5.3L Engine W/RPO HP2)
    GM1195696Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt idler pulley and bolt to the generator bracket.

    Snug the bolt finger tight.

  2. Install the drive belt. Refer to Drive Belt Replacement - Accessory (4.8L, 5.3L & 6.0L Engines)  or Drive Belt Replacement - Accessory (5.3L Engine w/RPO HP2) .
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the drive belt idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals