Cruise Control Indicator Inoperative (Without Throttle Actuator Control)
Cruise Control Indicator Inoperative (Without Throttle Actuator Control)
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Cruise Control Schematics Connector End View Reference: Cruise Control Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
- | Go to Step 3 | Go to Step 8 |
| 3 |
|
B+ | Go to Step 4 | Go to Step 5 |
| 4 | Test the cruise control engaged signal circuit for a short to voltage. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 10 | Go to Step 7 |
| 5 | Test the cruise control engaged signal circuit for an open or for a high resistance. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 10 | Go to Step 6 |
| 6 | Inspect for poor connections at the harness connector of the PCM. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 10 | Go to Step 9 |
| 7 | Replace the cruise control module. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 10 | - |
| 8 | Replace the IPC. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 10 | - |
| 9 | Replace the PCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 10 | - |
| 10 | Operate the system in order to verify the repair. Does the system operate properly? |
- | System OK | Go to Step 2 |