Cruise Control Indicator Always On (Without Throttle Actuator Control)
Cruise Control Indicator Always On (Without Throttle Actuator Control)
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Cruise Control Schematics Connector End View Reference: Cruise Control Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Turn the ignition ON, with the engine OFF. Does the Cruise indicator illuminate after the instrument panel cluster (IPC) displays test? |
- | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 3 |
|
- | Go to Step 4 | Go to Step 9 |
| 4 |
|
B+ | Go to Step 7 | Go to Step 5 |
| 5 | Test the cruise control engaged signal circuit for a short to ground. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 10 | Go to Step 6 |
| 6 | Inspect for a poor connection at the harness connector of the PCM. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 10 | Go to Step 8 |
| 7 | Replace the cruise control module. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 10 | - |
| 8 | Replace the PCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 10 | - |
| 9 | Replace the IPC. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 10 | - |
| 10 | Operate the system in order to verify the repair. Does the system operate properly? |
- | System OK | Go to Step 2 |