Cruise Control Indicator Always On (With Throttle Actuator Control)

Step	Action	Yes	No
Schematic Reference: Cruise Control Schematics Connector End View Reference: Cruise Control Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn ON the ignition, with the engine OFF. Does the Cruise indicator illuminate after the instrument panel cluster (IPC) displays test?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3	Turn OFF the ignition. Install a scan tool. Turn ON the ignition, with the engine OFF. With the scan tool, observe the Cruise Control parameter in the IPC Input/Output data list. Does the Cruise Lamp parameter display On?	Go to Step 4	Go to Step 5
4	Replace the powertrain control module (PCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 6	-
5	Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 6	-
6	Operate the system in order to verify the repair. Does the system operate properly?	System OK	Go to Step 2