LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Mechanical - 3.6L (Ly7) (3 Of 6)) >> Repair Instructions (On-Vehicle - Part 2 And Off-Vehicle - Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Crankshaft Balancer Removal

Crankshaft Balancer Removal

WARNING: This page is about a different car, the 2005 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

    Fig 1: View Of Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  1. Install the EN 46106  through the starter mounting hole. See Special Tools .
    2. Fig 2: View Of Crankshaft Balancer & Bolt
    GM902878Courtesy of GENERAL MOTORS CORP.
  2. Remove the crankshaft balancer bolt.
    3. Fig 3: Installing J 38416-2
    GM945980Courtesy of GENERAL MOTORS CORP.
  3. Install the J 38416-2  in the nose of the crankshaft. See Special Tools .
    4. Fig 4: Installing J 24420-C
    GM946041Courtesy of GENERAL MOTORS CORP.
  4. Install the J 24420-C  in order to remove the crankshaft balancer. See Special Tools .
    5. Fig 5: View Of Crankshaft Balancer
    GM946053Courtesy of GENERAL MOTORS CORP.
  5. Pull the crankshaft balancer off by tightening the center bolt on the J 24420-C  until the crankshaft balancer pulls off of the crankshaft end. See Special Tools .
  6. Remove the J 24420-C  from the crankshaft balancer. See Special Tools .
scientia non olet · About LEMON Manuals