LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Engine Mechanical - 3.6L (Ly7) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Engine Mount Bracket Replacement - Right (W/AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the right exhaust manifold. Refer to Exhaust Manifold Removal - Right (RWD) or Exhaust Manifold Removal - Right (AWD) in Engine Exhaust.
  3. Install a screw jack with a block of wood under the oil pan for support.
    4. Fig 1: View Of Right Engine Mount Upper Retaining Nut
    GM888310Courtesy of GENERAL MOTORS CORP.
  4. Remove the right engine mount upper retaining nut.
    5. Fig 2: View Of Right Engine Mount Bracket Mounting Bolts
    GM888307Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure not to distort or bend the engine mount heat shield.
  5. Remove the right engine mount bracket mounting bolts.
  6. Remove the engine mount bracket from the vehicle.
scientia non olet · About LEMON Manuals