LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Engine Mechanical - 3.6L (Ly7) (2 Of 6)) >> On-Vehicle Repair Instructions - Part 1 >> Drive Belt Tensioner Replacement - Power Steering And Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering & A/C Drive Belt Tensioner
    GM887771Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt tensioner and bolt to the engine as an assembly.
  2. Ensure that the alignment pin on the rear of the tensioner assembly is aligned with the locating hole on the engine.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the drive belt tensioner bolt.

    Tighten:  Tighten the drive belt tensioner bolt to 50 N.m (37 lb ft).

  4. Install the power steering and air conditioning drive belt. Refer to Drive Belt Replacement - Power Steering and Air Conditioning .
  5. Install the generator and water pump drive belt. Refer to Drive Belt Replacement - Generator and Water Pump .
scientia non olet · About LEMON Manuals