Section 114 (Engine Mechanical - 6.6L (Lb7) (Repair Instructions 4 Of 4))
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Repair Instructions (Off-Vehicle - Part 4)
- Cylinder Head Installation - Right
- Valve Rocker Arm, Shaft, and Push Rod Installation
- Valve Lash Adjustment
- Fuel Injector Sleeve Installation
- Fuel Injectors Installation
- Valve Rocker Arm Cover Installation - Lower Left
- Valve Rocker Arm Cover Installation - Lower Right
- Valve Rocker Arm Cover Installation - Upper Left
- Valve Rocker Arm Cover Installation - Upper Right
- Intake Manifold Installation - Left
- Intake Manifold Installation - Right
- Intake Manifold Tube Installation (Federal Emissions)
- Intake Manifold Tube Installation (California Emissions)
- Fuel Pipes and Fuel Rail Installation
- Fuel Filter Assembly Installation
- Thermostat Housing Installation
- Turbocharger Installation
- Glow Plug Controller and Glow Plugs Installation
- Exhaust Manifold Installation - Left
- Exhaust Manifold Installation - Right
- Fuel Injection Control Module Installation
- Fuel Injection Control Module Harness Assembly Installation
- Drive Belt Tensioner and Generator Mounting Bracket Installation
- Power Steering Pump Mounting Bracket Installation
- Cooling Fan Pulley Installation
- Engine Removal from Stand
- Engine Flywheel Housing Installation
- Oil Pan Installation - Upper
- Oil Pan Installation - Lower
- Exhaust Pipe Installation - Left
- Exhaust Pipe Installation - Right
- Exhaust Outlet Installation
- Crankshaft Rear Oil Seal Installation
- Engine Flywheel Installation (Automatic Transmission)
- Engine Flywheel Installation (Manual Transmission)
- Crankshaft Balancer Installation
- Starter Motor Installation