LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3) >> Repair Instructions (On-Vehicle And Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Sight Shield Replacement (4.8L, 5.3L & 6.0L W/RPO LQ4) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Sight Shield Retainer (4.8L, 5.3L & 6.0L)
    GM832095Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the sight shield retainer and the bolts, if required.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

    2. Fig 2: View Of Sight Shield (4.8L, 5.3L & 6.0L)
    GM832094Courtesy of GENERAL MOTORS CORP.
    NOTE: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
  2. Install the intake manifold sight shield to the retainer.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals