High Beam Indicator Inoperative

Step	Action	Yes	No
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn the ignition switch to the RUN position. Turn the headlamp switch to the ON position. Place the multifunction headlamp dimmer switch to the high beams position. Do the high beam indicator function properly?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Do the high beam headlamps function properly?	Go to Step 4	Go to Symptoms - Lighting Systems
4	Using a scan tool, select instrument panel cluster (IPC), Special Functions, and command the Lamp Test ON, then OFF. Does the high beam indicator lamp turn ON and OFF when commanded?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 5
5	Inspect for poor connections at the harness connector of the IPC. Refer to Circuit Testing andWiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 7	Go to Step 6
6	Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 7	-
7	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3