Cruise Control Indicator Inoperative (With Throttle Actuator Control)

Step	Action	Yes	No
Schematic Reference: Cruise Control Schematics Connector End View Reference: Cruise Control Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn the ignition OFF. Install a scan tool. Turn the ignition ON, with the engine OFF. With the scan tool, command the Cruise Control Lamp Test parameter On, in the instrument panel cluster (IPC) Special Functions. Does the Cruise indicator illuminate in the IPC?	Go to Step 4	Go to Step 3
3	Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 5	-
4	Replace the PCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 5	-
5	Operate the system in order to verify the repair. Does the system operate properly?	System OK	Go to Step 2