LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Yukon Denali >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Panel Replacement - Instrument Panel (I/P) Upper >> Installation Procedure

Installation Procedure

  1. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
    2. Fig 1: Connecting Electrical Connector To Ambient Light Sensor
    GM350507Courtesy of GENERAL MOTORS CORP.
  2. Install the trim panel to the IP assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the trim panel retaining screws.

    Tighten:  Tighten the trim panel retaining screws to 2 N.m (18 lb in).

    4. Fig 2: Installing I/P Assembly Trim Panel
    GM348717Courtesy of GENERAL MOTORS CORP.
  4. Install the windshield pillar garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
  5. Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
    6. Fig 3: Installing Assist Handle
    GM348728Courtesy of GENERAL MOTORS CORP.
  6. Install the right side air outlets.
  7. Install the end panels. The left panel is shown, and the right panel is similar.
    8. Fig 4: Installing End Panels
    GM348724Courtesy of GENERAL MOTORS CORP.
  8. Install the IP cluster trim plate bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster .
  9. Tilt the steering wheel to the normal driving position.
  10. If the transmission is automatic, move the shift lever to the park position.
  11. Disengage the parking brake.
scientia non olet · About LEMON Manuals