Charge Indicator Always On

Step	Action	Yes	No
1	Did you perform the Engine Electrical Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Engine Electrical
2	Turn ON the ignition, with the engine OFF. Observe the Charge indicator on the instrument panel cluster (IPC). Does the charge indicator illuminate?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3	Turn OFF the ignition. Disconnect the generator connector. Turn ON the ignition, with the engine OFF. Does the charge indicator remain illuminated?	Go to Step 4	Go to Step 5
4	Test the charge indicator control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 7	Go to Step 6
5	Replace the generator. Refer to Generator Replacement (4.3L) . Did you complete the replacement?	Go to Step 7	-
6	IMPORTANT: Perform the set up procedure for the PCM. Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement in Engine Controls-4.3L.Did you complete the replacement?	Go to Step 7	-
7	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3