LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Envoy RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Panel Replacement - Knee Bolster >> Installation Procedure

Installation Procedure

    Fig 1: Locating Knee Bolster Trim Panel
    GM712827Courtesy of GENERAL MOTORS CORP.
  1. Position the trim panel to the IP.
  2. Seat the clips that retain the trim panel to the IP.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 4 trim panel retaining screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About LEMON Manuals