Installation Procedure

Fig 1: Removing/Installing Bezel - Instrument Panel (I/P) Cluster (Chevrolet)

Courtesy of GENERAL MOTORS CORP.

If equipped, install the cigar lighter or 12-volt power supply outlets. Refer to Accessory Power Receptacle Replacement - 12 Volt in Power Outlets.
Install the rear wiper washer switch. Refer to Wiper/Washer Switch Replacement - Rear in Wipers Washer Systems.
If equipped, install the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement (GMC, Buick) or Transfer Case Shift Control Switch Replacement (Chevrolet) in Transfer Case.
Install the bezel to the instrument panel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws retaining the bezel to the instrument panel.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .