Installation Procedure

If installing a new trim plate, perform the following steps:
1. If equipped, install the cigar lighter or 12-volt power supply outlets. Refer to Accessory Power Receptacle Replacement - 12 Volt in Power Outlets.
2. Install the rear windshield wiper switch. Refer to Wiper/Washer Switch Replacement - Rear in Wiper/Washer Systems.

Fig 1: Removing/Installing Trim Plate - Instrument Panel (I/P) Accessory (Oldsmobile/Buick)

GM1208994

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors as necessary.
Install the trim plate to the IP. Ensure that all of the retaining clips are properly seated.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the lower trim plate retaining screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Oldsmobile, Buick) .