LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Envoy 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Knee Bolster
    GM712844Courtesy of GENERAL MOTORS CORP.
  1. Install the knee bolster to the steering column support bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 knee bolster retaining nuts.

    Tighten:  Tighten the nuts to 10 N.m (88 lb in).

  3. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  4. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About LEMON Manuals