LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Envoy 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Bracket Replacement - Console Floor >> Installation Procedure

Installation Procedure

  1. Install the floor shift control. Refer to Floor Shift Control Replacement in Automatic Transmission.
    2. Fig 1: Identifying Console Floor Bracket
    GM741605Courtesy of GENERAL MOTORS CORP.
  2. Install the console bracket to the vehicle.
  3. Loosely install all the fasteners that retain the console bracket to the vehicle.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the retaining nuts (1) to the center IP bracket.

    Tighten:  Tighten nuts to 10 N.m (88 lb in).

  5. Install the remaining fasteners that retain the console bracket to the vehicle.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  6. Connect the electrical connector to the park brake.
  7. Connect the electrical connector to the automatic transmission shift interlock solenoid.
  8. Connect the automatic transmission range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement in Automatic Transmission.
  9. Install the center console. Console Replacement 
  10. Install the floor shift control knob. Refer to Floor Shift Control Knob Replacement in Automatic Transmission.
  11. Remove the wheel blocks from the vehicle.
scientia non olet · About LEMON Manuals