LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different car >> Section 521 (Engine Mechanical (Repair Instructions -- 2 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (Off-Vehicle - Part 2) >> Crankshaft and Bearings Cleaning and Inspection >> Cleaning Procedure

Cleaning Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Use care when handling the crankshaft. Avoid damage to the bearing surfaces or the lobes of the crankshaft position reluctor ring. Damage to the teeth of the crankshaft position reluctor ring may effect On-Board Diagnostics (OBD) II system performance.
  1. Clean the crankshaft with solvent.
  2. Thoroughly clean all oil passages and inspect for restrictions or burrs.
    3. CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  3. Dry the crankshaft with compressed air.
    4. Fig 1: View Of Crankshaft
    GM156153Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals