Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the engine sight shield, if required. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (RPO LQ4)) or Engine Sight Shield Replacement (6.0L (RPO LQ9)) .
- Remove the connector position assurance (CPA) lock.
- Disconnect the main electrical connector (2) to the ignition coil wire harness.
- Remove the harness clips (1).
- Reposition the engine harness, if necessary.
- Remove the spark plug wires from the ignition coils.
- Twist each plug wire 1/2 turn.
- Pull only on the boot in order to remove the wire from the ignition coil.
- Remove the ignition coil bracket studs.
- Remove the ignition coil bracket.
- Remove the positive crankcase ventilation (PCV) hose.
- Loosen the valve rocker arm cover bolts.
- Remove the valve rocker arm cover.
- Remove and discard the old gasket (1).
- If required, clean and inspect the rocker arm cover. Refer to Valve Rocker Arm Cover Cleaning and Inspection .