LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil level indicator.
    2. Fig 1: View Of Oil Level Indicator
    GM1236365Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil level indicator tube bolt.
  3. Remove the oil level indicator tube from the engine block.
    4. Fig 2: View Of Oil Level Indicator Tube & Bolt
    GM1236364Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The O-ring seal may be reused if not cut or damaged.
  4. Inspect the O-ring seal for cuts or damage.
  5. Remove the O-ring seal from the tube, if required.
scientia non olet · About LEMON Manuals