LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the left engine mount to the engine.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount bolts to the engine.

    Tighten:  Tighten the engine mount bolts to 50 N.m (37 lb ft).

    3. Fig 1: View Of Left Engine Mount & Bolts
    GM679415Courtesy of GENERAL MOTORS CORP.
  3. Lower the engine.
  4. Remove the adjustable jack stands.
  5. For vehicles with 4WD, install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  6. Install the engine mount-to-engine mount bracket bolts. (Right side shown, left side similar).

    Tighten:  Tighten the engine mount-to-engine mount bracket bolts to 65 N.m (48 lb ft).

    7. Fig 2: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  7. Install the wheelhouse panel from the vehicle. Refer to Wheelhouse Panel Replacement in Body front End.
  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals